I’m Chris Harper, and with me is Makayla, and we’re here to demonstrate an application for wrist pain. This is when you have pain generalized in the back of the wrist or just over the wrist area. Some causes may be from working for prolonged periods on a computer, overuse in sports, landing on an outstretched hand, or carrying heavy loads. KT Tape helps treat this condition by relieving pressure to reduce pain, relaxing associated muscles, and may increase circulation. For this application we’re going to position the wrist with hand down, in.
A neutral or slightly flexed position. For my First piece, I’m going to take off a full strip. I’m folding that in half, and on the folded ends, we’re going to cut rounded corners. Rounding the corners helps prevent the tape from getting caught on clothing. I’m going to take my first piece, I’m going to twist and tear the backer paper right in the middle, and peel that back, being careful not to touch the adhesive part of the tape. This can affect it’s adhesion. So we’re going to place this on the back of the wrist with eighty percent stretch. What I’m going to do.
Is stretch that out a hundred percent, and back that off just a little bit. I’m going to place that down, and without going fully around the wrist, I’m just going to pinch that off so it’s adhered well. Then I’m going to apply the tail ends of the tape with absolutely zero stretch. So I’m just applying that down and peeling that paper off. Make sure that’s stuck. And then take this one off with absolutely zero stretch. For my remaining piece that I cut, I’m tearing that in the same manner,.
KT Tape Wrist
Twisting and tearing the paper and peeling that paper back. I’m going to apply pressure nice and evenly with my thumbs, avoiding pulling the paper with my thumbs in the middle, but more like this. And we’re going to apply at eighty percent , so stretching fully and then backing off a little bit. And just put that down on the wrist and pinch off those ends. The reason I do this is I don’t want to form a tourniquet around the wrist. So that’s why we’re not using one full piece, were actually.
Using two half pieces to do this. I’m going to lay these ends down with zero stretch just like I did with that first piece. So I’m just taking that backing paper off and laying those ends down very carefully with the no stretch. Okay. For the third part of this, I’m going to take another full strip. This time I’m going to find the logo end of the tape. I’m going to twist and tear the backing paper to form an anchor on the end. Again I’m being very careful not to touch the adhesive of the tape.
We’re going to place the wrist in a flexed position. I’m going to place the anchor on the top of the hand with absolutely zero stretch. I’m just giving that a little rub so it adheres well. I’m going to peel that people backing off trying not to touch the adhesive and leaving a little bit of paper on the end for me to handle the tape without touching that adhesive. So I’m going to place this on twenty five percent stretch, so if I stretch that fully, back that off and back off half way again.
And lay that tape down all the way up the arm, except I’m going to leave this last little bit with absolutely zero stretch. So, twenty five percent stretch, and I’m going to give the whole thing a good friction rub just to make sure it’s well adhered. Okay, that looks good. Some helpful tips before applying are to clean the skin very well, remove any lotions or skin oils. Be careful with washing your hands, you may want to pat the area dry so you don’t roll the tape. Also, shaving or trimming the area of any excessive hair is helpful in adhesion to.